Abstract: The non-destructive measurement of charged particle beams with intensities below 1 μA represents still a challenge in current R&D efforts. Beam peak-intensities of modern high power accelerators are in the range of milli-amperes, but for a large number of experiments, the pulse lengths have to be increased by several orders of magnitude (slow extraction process) to avoid saturation in the detectors. At the same time, the intensities of exotic ion- or antiproton-beams – depending on the production yield – might be in the range of nano-amperes or even below. The solution of this measurement problem should moreover include the possibility to calibrate the electrical current with traceability to national standards.
Abstract: A new Cryogenic Current Comparator with eXtended Dimensions (CCC-XD), compared to earlier versions built for GSI, is currently under development for a non-destructive, highly-sensitive monitoring of nA-intensities of beams for larger beamline diameters planned for the new FAIR accelerator facility at GSI. The CCC consists of a:
1) flux concentrator,
2) superconducting shield against external magnetic field and a
3) superconducting toroidal coil of niobium which is read out by a
4) Superconducting Quantum Interference Device (SQUID).
The new flux concentrator (1) comprises a specially designed highly-permeable core made of nano-crystalline material, in order to assure low-noise operation with high system bandwidth of up to 200 kHz. The superconducting shielding of niobium (2) is extended in its geometric dimensions compared to the predecessor CCC and thus will suppress (better -200 dB) disturbing magnetic fields of the beamline environment more effectively. For the CCD-XD readout, new SQUID sensors (4) with sub-μm Josephson junctions are used which enable the lowest possible noiselimited current resolution in combination with a good suppression of external disturbances. The CCC-XD system, together with a new dedicated cryostat, will be ready for testing in the CRYRING at GSI in spring 2017. For the application of a CCC in the antiproton storage ring at CERN a pulse shape correction has been developed and tested in parallel. Results from electrical measurements of two components (1 and 4) of the new CCC-XD setup will be presented in this work.
Johann Wolfgang Goethe-Universität Frankfurt, Fachbereich Physik (2016)
Abstract: The planned Facility for Antiproton and Ion Research (FAIR) at GSI has to cope with a wide range of beam intensities in its high-energy beam transport systems and in the storage rings. To meet the requirements of a non-intercepting intensity measurement down to nA range, it is planned to install a number of Cryogenic Current Comparator (CCC) units at different locations in the FAIR beamlines. In this work, the first CCC system for intensity measurement of heavy ion beams, which was developed at GSI, was re-commissioned and upgraded to be used as a 'GSI - CCC prototype' for extensive optimization and development of an improved CCC for FAIR. After installation of a new SQUID sensor and related electronics, as well as implementation of improved data acquisition components, successful beam current measurements were performed at a SIS18 extraction line. The measured intensity values were compared with those of a Secondary Electron Monitor (SEM). Furthermore, the spill-structure of a slowly extracted beam was measured and analyzed, investigating its improvement due to bunching during the slow-extraction process. Due to the extreme sensitivity of the superconducting sensor, the determined intensity values as well as the adjustment of the system for optimal performance are strongly influenced by the numerous noise sources of the accelerators environment. For this reason, detailed studies of different effects caused by noise have been carried out, which are presented together with proposals to reduce them. Similarly, studies were performed to increase the dynamic range and overcome slew rate limitations, the results of which are illustrated and discussed as well.
By combining the various optimizations and characterizations of the GSI CCC prototype with the experiences made during beam operation, criteria for a more efficient CCC System could be worked out, which are presented in this work. The details of this new design are worked out with respect to the corresponding boundary conditions at FAIR. Larger beam tube diameters, higher radiation resistivity and UHV requirements are of particular importance for the cryostat. At the same time these parameters affect the CCC superconducting magnetic shielding, which again has significant influence on the current resolution of the system. In order to investigate the influence of the geometry of the superconducting magnetic shield on different magnetic field components and to optimize the attenuation, FEM simulations have been performed. Based on the results of these calculations, modifications of the shield geometry for optimum damping behavior are proposed and discussed in the thesis.